Can orcaflex do pipe in pipe analysis12/3/2022 ![]() Tramontana Engineering has provided offshore contractors with working inline joint and omega joint overboarding analyses using OrcaFlex. Tramontana Engineering has experience on several offshore cable installation projects where these joints had to be installed or planned for. When a cable repair has to be performed or when a cable route is too long to install in one length, an offshore cable joint is required. Tramontana Engineering can provide the vessel specific Second end Pull-in models, laytables and weather limitations to be used for Client and Marine Warranty acceptance. ![]() Second end pull-in models follow the same principle as the first end pull-in models, however now the pull-in will be performed using a quadrant on board the cable lay vessel. Tramontana Engineering is specialized in providing engineering support during OrcaFlex workscopes as well as preparing solid OrcaFlex models and reports. ![]() The analyses shall provide the integrity limits of the pipe and provide the weather conditions in which the pipe can be installed.Īpart from actual pipeline installation analyses, OrcaFlex is a good tool to perform Free Span analysis of a future pipeline route as well as as-laid pipelines.įor cable installation we can make a distinction in between several offshore operations, such as pull-ins, joint installation and normal lay. This is highly beneficial for last minute adaptations in the project schedule, upgrading environmental limits offshore and increasing weather windows by performing quick analyses during the project execution reducing or avoiding potential downtime during the project execution.įor pipeline installation operations, OrcaFlex can be used to perform, among others Stab-in, Midline tie-in, Abandonment and Recovery and Normal Lay operations.įor these operations OrcaFlex can be utilized to model the stinger setup on the pipelay vessel or model the vertical lay tower. Using smart setups of the models, Pull-ins can be performed in very short time frames. Tramontana Engineering has experience in performing these analyses for a fast amount of offshore windfarms and is known to provide very quick and high quality analyses results. ![]() Using hands on experience, tailor-made solutions can be provided for different offshore operations using the OrcaFlex software. By performing static and dynamic OrcaFlex analysis, installation operations can be carried out, marine warranty can be guaranteed and workability assessments can be provided. Tramontana Engineering is specialized in Cable and Pipeline Integrity analysis using OrcaFlex Software. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |